Waldstetten · Germany

SAFETY & DISPOSAL

Disposal Regulations

Gas springs from CB-Motion consist predominantly of metal and can be fed into the respective material recycling stream. The springs and coil springs are made of metal and can be sent for material recycling.

Gas springs must first be depressurized. Any oil contained must be drained and disposed of separately if necessary. Please note: CB-Motion gas springs are under very high pressure.

Procedure

In the event of opening a gas spring, the following points must be strictly observed and taken into account.

1) No persons may be located in front of or behind the extended axis of the gas spring, and the gas spring must not point towards any persons!

The gas spring must not be sawn open or clamped before carrying out point 2 below! 2) Clarify which design type the gas spring belongs to. For standard gas pressure springs, drill into the gas spring in its extended state approx. 3-4 cm from the cylinder base toward the piston rod at low speed (drill bit diameter max. 3 mm).

3) Due to internal pressure, contamination with oil and metal shavings may occur. Appropriate protective measures must be taken. 4) Opening the cylinder voids the warranty.

Disposal of Components

All components must be disposed of properly and in accordance with generally applicable regulations for the respective materials!

Upon request, we would be pleased to submit an offer for the disposal of your gas springs.

As of October 2026 | www.cb-motion.de